The Finishing Department has the following openings to be filled: Assembler, Metallizer and Blaster.

As an Assembler you assemble various components inside a tower section. You put parts together one by one while using different methods to build a product that matches our high quality standards. You must be able to:

• Prepare and assemble various components inside a tower section such as: bus-bar systems, platforms, ladders, mechanical components, etc;
• Pre-assemble the hardware used for platform assembly, ladders, etc.;
• Cut and prepare electric cables;
• Drill holes in the aluminum trays to attach the neon lights and electrical boxes;
• Assemble parts in preparation for the lift;
• Perform final inspection of each section and install a tarp at each end of the section;
• Complete the quality documentation required;
• Operate forklifts, aerial lifts and scissor lifts as required.
• Perform all other duties as assigned by the Production Supervisor such as: perform various touch-ups, clean the sections, etc.

As a Metallizer, you are responsible for the surface coating of parts. You treat surfaces to protect them from rust and corrosion in order to offer higher quality products. You must be able to:

• Prepare the part before metallization: clean the part, remove screws from anchorages and verify the quality of threads;
• Apply an anticorrosive substance on the part using an arc gun;
• Carry out a visual inspection of the part;
• Sand and deburr the surfaces to meet the quality standards;
• Inspect the part using measuring instruments (surface finish, thickness of coating);
• Complete the quality and the production documents;
• Handle various equipment using overhead cranes our forklifts;
• Perform all other duties that will support your team in the achievement of the department’s objectives.

As a Blaster you perform mechanical shot blast of the entire wind tower section and manual shot blast of the flanges to build a product that matches our high quality standards. You must be able to:

• Prepare the booth for the arrival of the section: cleaning, identification, etc.;
• Perform the assembly and disassembly of the mechanical equipment in the blast booth;
• Perform mechanical shot blast of the entire wind tower section and manual shot blast of the flanges;
• Perform visual inspection of the section (color, rust or surface defaults);
• Remove all particles after the section is blasted;
• Inspect the part using measuring tools (thickness, finishing surface);
• Complete the quality documents;
• Move different equipment using the overhead crane or forklift;
• Perform all other duties as assigned by the Production Supervisor.

#marp2