TOOLING SPECIALIST at Fineline Industries LLC – Merced, California

We are seeking a highly skilled Tooling Specialist to join our team! In this position, the Tooling Specialist will work with the Research and Development team to build all our new products and/or parts.

To be successful as a Tooling Specialist, you must be able to perform a wide variety of tasks that require stamina and an eagerness to learn on the job. A good Tooling Specialist can understand instructions and carry them out efficiently within the given deadline.

Essential Duties | Responsibilities

· Responsible for sanding, buffing, and waxing molds.

· Measure and mix correct catalyst ratios of resins.

· Use various hand tools to apply and roll out wet fiberglass materials properly without air voids.

· Keep work area clean and orderly.

· Painting hulls, decks and stringers using gelcoat.

· Follow all application guidelines and instructions for quality control.

· Any other duties as assigned by management.

· High School Diploma or Equivalent

· One or more years of experience in general labor.

· Ability to use hand and pneumatic tools.

· Must be able to perform tasks under time pressure deadlines.

· Must have strong attention to detail.

· Able to understand and follow verbal and written directions.

· Must be able to work well with teams and in close proximity to each other.

· Skills in fiberglass, resin, and/or Bondo preferred.

Physical Requirements

· Must be able to work in non-climate-controlled environment where ambient air temperature can exceed outside air temperature.

· Must be able to bend at waist, knees and stand for extended periods of time.

· Must be able to climb into and out of interior of boats.

· Must be able to wear proper safety equipment to include respirator when necessary.

· Must be able to lift 50 pounds when necessary.

Work Environment

Work environment characteristics described here are representative of those that must be met by an employee to successfully perform the essential function of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

While performing the duties of this job, the employee may be exposed to weather conditions, normal office environment or factory environment that is not climate controlled. The noise level in the work environment is usually moderate. The factory in certain areas maintains a high fiberglass and dust environment.

Personal Protective Equipment might be required in certain areas of the factory including but not limited to safety glasses, respirator, hearing protection, gloves and protective garments.

Equal Employment Opportunity Employer

C&S Boat Company provides equal employment opportunities (EEO) to all employees and applicants for employment without regard to race, color, religion, sex, national origin, age, disability or genetics. In addition to federal law requirements, C&S Boat Company complies with applicable state and local laws governing nondiscrimination in employment in every location in which the company has facilities. This policy applies to all terms and conditions of employment, including recruiting, hiring, placement, promotion, termination, layoff, recall, and transfer, leaves of absence, compensation and training.